Switch>enable
Switch#config termi
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
switch#config termi
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#interface fastethernet 0/0
%Invalid interface type and number
switch(config)#interface fastethernet 0/1
switch(config-if)#
switch(config-if)#shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down
switch(config-if)#no shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
switch(config-if)#shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down
switch(config-if)#no shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
switch(config-if)#shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down
switch(config-if)#no shut
switch(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
No comments:
Post a Comment